- FlexxPump
- 402B
- What do I do if the lid of the cartridge is in the lubricant instead of above it?
- Replacing the battery 402B
Replacing the battery 402B
CAUTION
Leaking batteries
Battery fluids and their fumes are hazardous to the environment, corrosive and poisonous! They cause injury to persons and damage to property!
- Observe the following points:
- Make sure there is good ventilation in closed rooms before repairing leaks
- Wear safety goggles and gloves
- Prevent battery fluids from getting into the drinking water supply
- Use only dry cleaning cloths without detergents
- Dispose of batteries in an environmentally friendly manner
NOTE
Empty battery
A battery charge lasts for one cartridge only. An empty battery causes material damage to the entire system due to inadequate lubrication.
- Replace the battery simultaneously with the cartridge.
- Use only Güdel batteries. Only then can a sufficient battery charge be guaranteed.
- Immediately replace the battery when error message E3 appears.
HINT
The FlexxPump contains a capacitor. The capacitor stores the supply voltage for 30 seconds. Strictly wait for 30 seconds before attaching the plug to the new battery. Only then will the capacitor be fully discharged and the error message E3 is reset correctly.
A | Battery | ||
B | Plug |
Replace the battery as follows:
- The cartridge is removedReplacing the cartridge
- Remove battery
- Loosen plug
- Wait for 30 seconds
- Attach plug to new battery
- Insert new battery
- Install cartridge
- Switch on the FlexxPumpSwitching on the FlexxPump 402/402B
- Carry out a special dispensingSpecial dispensing
- The battery is replaced.
