Overcurrent E2
The red LED flashes every 5 seconds. Pressure too high (>70 bar). The FlexxPump stops operating.
Remove the blockage as follows:
Table of contents
- Revision history
- 404DLS
- loading...
- 402
- loading...
- 402B
- Further applicable documentation
- Does the carrier have to move on initial lubrication?
- What can I use to initially lubricate the guideways and racks?
- Does the pump have to be mounted on the carrier?
- What maximum hydraulic line length is permitted?
- loading...
- Are the hydraulic lines prefilled ex works?
- Can I use the same lubrication quantities and intervals during start-up phases as during operation?
- What effect do extended commissioning phases have on the lubrication system?
- How do I determine the correct lubricant quantity?
- loading...
- Is there an ideal value for the lubrication parameters [km] or [h]?
- What happens if the lubrication settings are incorrect?
- How do I find out if the automatic lubrication is functioning correctly?
- loading...
- What error messages are possible?
- Display element and malfunctions
- Empty E1
- Overcurrent E2
- Operating voltage too low E3
- Internal electrical error E4
- Internal mechanical error E5
- System malfunction
- How happens to the lubrication system during long downtimes >2 months?
- How long does the battery last?
- Is it really necessary to replace the battery at the same time as the cartridge?
- What do I do if the lid of the cartridge is in the lubricant instead of above it?
- loading...
- How do I replace the cartridge?
- loading...
