Filling hydraulic lines / venting the FlexxPump
The following signal on PIN 2 causes 20 x 0.15 cm3 of lubricant to be dispensed at each of the four hydraulic outputs:
Accuracy of the impulses (High) on PIN 2: +/- 0.2s or +/- 10%!
The filling process starts with the displayed signal on PIN 2. The filling process takes a maximum of 1600 seconds. The filling process is continued after the FlexxPump is switched on if it was interrupted by switching off the FlexxPump. The output signal at PIN 4 is High (+20...30V) during normal operation. During an actual motor run of the FlexxPump, the signal switches to Low (+0V). Normally this takes between approx. 9 and 18 seconds, depending on the length of the hydraulic hoses and the viscosity of the lubricant. The signal then switches back to High (+24V).
